Panasonic KX-T336 System Reference Manual page 323

10.02 DTMF Tone Integration
Description
Programming
On extensions with the Voice Mail Port parameter enabled, the KX-T336
system can send codes (DTMF tones) to indicate the sate of the call
(busy, answered, ringing, disconnect, etc.) in addition to the normal call
progress tones. These codes enable the Voice Processing system to
immediately recognize the current state of the call and improve its call
handling performance. These codes apply to all incoming calls: Outside
calls only indicate disconnect (provided the KX-T336 system is
programmed properly for CPC detection and the Central Office sends the
CPC signal).
1) Press CTRL key and V key simultaneously when Main Menu
screen is displayed at VT programming mode.
2) Enter P R G and press Return key when Dumb programming
mode initial prompt (;>) is displayed. Then programming mode initial
prompt (; PRG>) is displayed on the screen.
3) At the programming prompt (PRG>), type:
; PRG > WS 3 AT 3
The screen displays the Input prompt (INPUT >>) as follows:
; PRG > WS 3 AT 3
; 3 : DTMF-Tone Integration.............. N
; INPUT >>
4) At the Input prompt (INPUT >>), type:
; PRG > WS 3 AT 3
; 3 : DTMF-Tone Integration............... N
; INPUT >> Y
5) The screen displays the Input prompt (INPUT >>) for Item 1 as
follows:
; PRG > WS 3 AT 3
; 3 : DTMF-Tone Integration............... N
; INPUT >> Y
; 1 : DIL 1:N CO Key Only ................. N
; INPUT >>
6) To store the new assignment to the system, at Input prompt
(INPUT >>), type:
; PRG > WS 3 AT 3
; 3 : DTMF-Tone Integration............... N
; INPUT >> Y
; 1 : DIL 1:N CO Key Only ................. N
; INPUT >> $ EOD
This assigns the DTMF-Tone Integration feature to the system, and the
programming prompt (PRG>) appears on the screen again.
3-F-21
(21292)
(↵ )
(↵ )
(↵ )