Panasonic KX-T336 System Reference Manual page 199

8.05 Switching of Day/Night Mode
Description
It is assignable to switch Day/Night mode either
automatically at pre-assigned time or manually
by the Operator 1 (Attendant Console or
Extension) at any time desired.
If Manual Switching mode is assigned, the
Operator 1 must dial the feature number for
"Night Mode Set" for night service or "Night Mode
Cancel" for day service.
If Auto Switching mode is assigned, the system
will switch the day and night modes at the
programmed time each day.
To utilize Auto Switching mode, set "System-
Operation (3/3)" Night Service to "Auto" and
assign desired mode switching time to "Auto
Start Time" on a per day of the week basis.
To utilize Manual Switching mode, set "System-
Operation (3/3)" Night Service to "Manual."
The Operator 1, however, can override the Auto
Mode setting, that is Manual Mode can be
established, by dialing the feature number for
"Night Service Manual Mode Set." To restore the
Auto mode, the Operator 1 must dial the feature
number for "Night Service Manual Mode Cancel."
If tenant service is employed, night service
assignment unique to each tenant (Tenant 1 and
Tenant 2) can be programmed individually.
The assignment in "System-Operation (3/3)" is
applied to Tenant 1 and the assignment in
"System-Tenant" is applied to Tenant 2.
Programming
System Programming
"System-Operation (3/3)",
Night Service
Auto Start Time
"System-Tenant",
Night Service (Tenant 2)
Auto Start Time
"System-Numbering Plan
(08/11)",
Night Mode Set
Night Mode Cancel
Night Service Manual Mode
Set
Night Service Manual Mode
Cancel
Reference
VT Dumb
9-D-1.03 10-C-4.00
9-D-2.00 10-C-5.00
9-D-6.08 10-C-10.00
3-B-18
(70695)
Conditions
If Auto Start Time on a certain day is not
assigned, the current mode is continued until a
new start time is encountered.
If the Start Time for Day mode and Night mode
on the same day are set identically, the current
mode is continued.
If Auto Start Time assignment is not programmed
at all, the current mode is continued. In other
words if the current mode is Day then Day Mode
is continued, and if the current mode is Night
then Night Mode is continued.
Operation
Refer to the following:
(PITS) Section 4-I-1.03 "Switching of Day/Night
Mode"
(SLT) Section 5-G-1.03 "Switching of Day/Night
Mode"
(ATT) Section 6-J-1.02 "Switching of Day/Night
Mode"