Table of Contents
Advertisement
Replacing a ZS3-4 Power Supply
Storage controllers are equipped with redundant hot-swappable power supplies. If a power
supply fails and you do not have a replacement, leave the failed power supply installed to
ensure proper air flow. A faulted power supply is indicated by an amber colored status LED.
Use the following procedure to replace a ZS3-4 power supply.
1.
Gain access to the rear of the storage controller where the faulted power supply
is located.
2.
If a cable management arm (CMA) is installed, press and hold the CMA release
tab and rotate the arm out of the way.
Disconnect the power cord from the faulted power supply.
3.
Replacing a ZS3-4 Power Supply
Servicing the ZS3-4 Controller
93
Hide quick links:
Advertisement
Table of Contents
