Table of Contents
Advertisement
18.
Go to the Maintenance > Hardware screen of the BUI. Click the right-arrow icon
for the controller and then click DIMM to verify that the online icon
green for the newly installed DIMM.
If a fault does not self-clear, see
19.
Replacing a 7x20 Controller PCIe Card or Riser
This procedure requires that you handle components that are sensitive to static
Caution -
discharge, which can cause the component to fail. To avoid damage, wear an antistatic wrist
strap and use an antistatic mat when handling components. Note that the 7120 Sun Flash
Accelerator F20 card is a FRU and must be replaced by an Oracle service representative.
Go to the Maintenance > Hardware screen of the BUI and click the right-arrow icon
controller, and then click Slots to locate the faulted component. All HBAs must be of the same
type. Ensure that you upgrade your system software before installing a newly released HBA.
1.
Power off the storage controller as described in
Controller" on page
Disconnect the AC power cords from the rear panel of the storage controller.
2.
Because 3.3 VDC standby power is always present in the system, you must unplug
Caution -
the power cords before accessing any cold-serviceable components.
3.
Extend the controller from the rack as described in
Controller from the Rack" on page
7120 or 7320: To remove the top cover:
4.
a.
Unlatch the fan module door, pull the two release tabs back, rotate the fan
door to the open position and hold it there.
b.
Press the top cover release button and slide the top cover to the rear about
a half-inch (1.3 cm).
c.
Lift up and remove the top cover.
7420: To remove the top cover:
5.
"Repairing Active Problems" on page
50.
51.
Replacing a 7x20 Controller PCIe Card or Riser
"Powering Off the
"Extending the Storage
Servicing the 7x20 Controller
is
37.
on the
197
Hide quick links:
Advertisement
Table of Contents
