Replacing A Zs3-4 Pcie Card Or Riser - Oracle ZFS Storage Appliance Service Manual

Replacing a ZS3-4 PCIe Card or Riser

16. Go to the Maintenance > Hardware screen of the BUI, click the right-arrow icon
on the controller, and click DIMM to verify the status of the new component.
The online icon
17. If a fault does not self-clear, see
Replacing a ZS3-4 PCIe Card or Riser
Caution -
discharge, which can cause the component to fail. To avoid damage, wear an antistatic wrist
strap and use an antistatic mat when handling components.
Go to the Maintenance > Hardware screen of the BUI and click the right-arrow icon
controller, and then click Slots to locate the faulted component. All HBAs must be of the same
type. Ensure that you upgrade your system software before installing a newly-released HBA.
1. Shut down the controller using one of the power-off methods described in
"Powering Off the Controller" on page
Disconnect the AC power cords from the rear panel of the storage controller.
2.
Caution -
the power cords before accessing any cold-serviceable components.
3. Extend the controller from the rack as described in
Controller from the Rack" on page
4. Remove the top cover as described in
5. Locate the PCIe card position in the storage controller, see
Cards" on page
6. To replace the PCIe card:
104 Oracle ZFS Storage Appliance Customer Service Manual • July 2016
should be green.
This procedure requires that you handle components that are sensitive to static
Because 3.3 VDC standby power is always present in the system, you must unplug
121.
"Repairing Active Problems" on page
50.
"Extending the Storage
51.
"Removing the Top Cover" on page
37.
on the
52.
"ZS3-4 PCIe I/O