Zs3-2 Optional Cable Management Arm - Oracle ZFS Storage Appliance Service Manual

ZS3-2 Controller Hardware Overview
Slot
4-6
4-6
ZS3-2 NIC/HBA Options - The following table describes the NIC/HBA options for the ZS3-2
controller.
TABLE 28
Mktg Part Number
SG-SAS6-INT-Z
SG-XPCIE2FC-QF8-Z
7103791
7101674
X1109A-Z
X4242A
7100477
7100488
X2129A
X5562A-Z
ZS3-2 PCIe Riser Configuration - The three risers are labeled Riser 1, Riser 2, and Riser
3. Though similar, the risers are not interchangeable. Riser 1 installs at the left rear of the
chassis, Riser 2 at the center rear, and Riser 3 at the right rear of the chassis. Each riser can
accommodate two PCIe cards:
Riser 1 contains slots 1 and 4
■
Riser 2 contains slots 2 and 5
■
Riser 3 contains slots 3 and 6
■

ZS3-2 Optional Cable Management Arm

The following figure identifies the components of the second-generation cable management arm
(CMA). See the CMA installation instructions.
170 Oracle ZFS Storage Appliance Customer Service Manual • July 2016
Mfg Part Number
7051223
7070006
ZS3-2 Controller NIC/HBA Options
Description Max
2-port 10Gb Ethernet 4
Optical NIC
2-port 10Gb Ethernet 4
Copper Base-T NIC
Description
8-port 6Gb/s SAS-2 internal HBA
2-port 8Gb FC HBA
4-port (4x4) SAS-2 6Gb/s external HBA
2-port 16Gb FC HBA
2-port 10GbE SFP+ NIC
2-port InfiniBand CX2 HCA
4-port 1Gb Ethernet Copper UTP NIC
2-port 10Gb Ethernet Copper Base-T NIC
XCVR 850NM, 1/10GPS, SFP, short reach
10GbE/1GbE SFP+ Transceiver, long reach
Note
Optional
recommended front-
end
Optional
recommended front-
end