Table of Contents
Advertisement
15.
Reconnect the power cords to the power supplies.
16.
Verify that standby power is on, indicated by the Power/OK status indicator
flashing on the front panel about two minutes after the power cords are plugged
in.
17.
Use a pen or other pointed object to press and release the recessed Power
button on the storage controller front panel. The Power/OK status indicator next
to the Power button lights and remains lit.
18.
Connect data cables to the PCIe card, routing them through the cable
management arm, if used.
19.
Go to the Maintenance > Hardware screen of the BUI. Click the right-arrow icon
for the controller, click Slot, and verify that the status icon
newly installed card. To view details about the new card, click its information
icon.
20.
If a fault does not self-clear, see
If you replaced an HBA, connect the disk shelves to it as described in
21.
"Connecting to Attached Storage" on page
HBA, install the disk shelf as described in
Hardware Overviews" in Oracle ZFS Storage Appliance Installation Guide
and connect the expansion storage as described in
Storage" on page
Replacing a ZS4-4 Battery
Replacing a system battery is a cold-swap procedure, and you must remove power from
the storage controller. You might need to replace the battery if the storage controller fails to
maintain the proper time when powered off and disconnected from the network. You will need a
small (No.1 flat-blade) non-metallic screwdriver or equivalent. Use the following procedure to
replace a ZS4-4 system battery.
1.
Shut down the controller using one of the power-off methods described in
"Powering Off the Controller" on page
2.
Disconnect the AC power cords from the rear panel of the storage controller.
Caution -
Because 3.3 VDC standby power is always present in the system, you must unplug
the power cords before accessing any cold-serviceable components.
"Repairing Active Problems" on page
272.
272. If you installed a new
"Installation Prerequisites and
"Connecting to Attached
50.
Servicing the ZS4-4 Controller
Replacing a ZS4-4 Battery
is green for the
37.
71
Hide quick links:
Advertisement
Table of Contents
