Replacing A 7X20 Dimm - Oracle ZFS Storage Appliance Service Manual

Replacing a 7x20 DIMM

6. Slide the power supply into the bay until it is fully seated. The following figure
shows the 7420 power supply.
7. Connect the power cord to the power supply.
8. Verify that the green AC Present status indicator is lit.
9. Close the CMA, inserting the CMA into the rear left rail bracket.
10. Go to the Maintenance > Hardware screen of the BUI. Click the right-arrow icon
for the controller and then click PSU to verify that the online icon
for the newly installed power supply.
11. If a fault does not self-clear, see
Replacing a 7x20 DIMM
Caution -
discharge, which can cause the component to fail. To avoid damage, wear an antistatic wrist
strap and use an antistatic mat when handling components.
184 Oracle ZFS Storage Appliance Customer Service Manual • July 2016
This procedure requires that you handle components that are sensitive to static
"Repairing Active Problems" on page
is green
37.