Service Processor; Cli Hardware View - Oracle ZFS Storage Appliance Service Manual

CLI Hardware View

Service Processor

The service processor behaves differently from other component nodes. Instead of providing
a list of components, it presents a set of network properties that can be configured from the
storage appliance. The following properties control the behavior of the service processor
network management port.
TABLE 7
Property
MAC Address
IP Address Source
IP Address
Subnet
Default Gateway
Changing multiple values in conflicting ways (such as changing static IP assignments while in
DHCP mode) has undefined behavior.
CLI Hardware View
Hardware status details are available in the CLI under the maintenance hardware section. Use
the show command to list the status of all components. The list command will list available
chassis, which can be selected and then viewed using show.
hostname:> maintenance hardware show
Chassis:
chassis-000 0839QCJ01A
cpu-000
cpu-001
cpu-002
cpu-003
disk-000
disk-001
26 Oracle ZFS Storage Appliance Customer Service Manual • July 2016
Properties for the Service Processor Network Management Port
Description
Hardware MAC address. This is read-only
Either 'DHCP' or 'Static'. Controls whether DHCP should be used on the
interface.
IPv4 Address, when using static IP configuration. IPv6 is not supported.
Dotted decimal subnet, when using static IP configuration.
IPv4 default gateway address.
NAME STATE
ok
CPU 0 ok
CPU 1 ok
CPU 2 ok
CPU 3 ok
HDD 0 ok
HDD 1 ok
MANUFACTURER
Sun Microsystems, Inc. Sun Storage 7320
AMD
AMD
AMD
AMD
STEC
STEC
MODEL
Quad-Core AMD Op
Quad-Core AMD Op
Quad-Core AMD Op
Quad-Core AMD Op
MACH8 IOPS
MACH8 IOPS