Omron LD User Manual page 60

Caster Cables
These should be adjusted correctly from the factory. If any adjustment is needed, refer to the
preceding figure for the adjustment location. The brake pins should be able to go down as far
as the caster surface allows, without any slack. The jam nuts on the two brake adjustments
should be installed using a threadlocker.
Actuator Bar Hard Stop
After the caster cables are adjusted correctly, ensure that the actuator bar just touches its hard
stop. This will keep the actuator bar in position if you have to adjust the lever cable.
LD Cart Transporter User's Guide, 14766-000 Rev B
Chapter 3: Setup
Page 60 of 190