Hex-Ascii Display Change; Displaying The Cycle Time - Omron CPM2C-S100C Operation Manual

Programming Console Operations

8-2-28 Hex-ASCII Display Change

1,2,3...
Note

8-2-29 Displaying the Cycle Time

1,2,3...
3. Press the NOT Key to clear the force-set/reset status of bits in all data ar-
eas.
This operation is used to convert word data displays back and forth between
4-digit hexadecimal data and ASCII. It is possible in any mode.
The displayed PV of the timer or counter cannot be changed.
RUN
OK OK
1. Monitor the status of the desired word(s) according to the procedure de-
scribed in 8-2-14 Bit, Digit, Word Monitor. While the multiple addresses are
being monitored, the leftmost word is subject to change.
(Multiple address monitor)
2. Press the TR Key to switch to ASCII display. The display will toggle be-
tween hexadecimal and ASCII displays each time the TR Key is pressed.
1. A message contained in three words can be displayed by using ASCII dis-
play in combination with the Three-word monitor operation.
2. The Hexadecimal, BCD Data Modification Operation can be used while
displaying ASCII data. Input values in 4-digit hexadecimal.
This operation is used to display the current average cycle time (scan time). It
is possible only in RUN or MONITOR mode while the program is being exe-
cuted.
RUN
OK OK
1. Press the CLR Key to bring up the initial display.
2. Press the MONTR Key to display the cycle time.
MONTR
There might be differences in displayed values when the MONTR Key is
pressed repeatedly. These differences are caused by changing execution
conditions.
00000FORCE RELE
END
NOT
MONITOR PROGRAM
OK
, ,
" " ! !
, ,
)* ! !
TR
, ,
" " ! !
TR
MONITOR PROGRAM
No
00000SCAN TIME
"MS" in the display indicates
the unit "ms" for the cycle time.
Section 8-2
012.1MS
191