Buzzer Operation; Assigning Expansion Instruction Function Codes - Omron CPM2C-S100C Operation Manual

Programming Console Operations
8-2-6

Buzzer Operation

Key Sequence
1,2,3...
8-2-7

Assigning Expansion Instruction Function Codes

1,2,3...
170
All messages cleared:
MONTR
This operation is used to turn on and off the buzzer that sounds when Pro-
gramming Console keys are pressed. This buzzer will also sound whenever
an error occurs during PC operation. Buzzer operation for errors is not
affected by this setting.
This operation is possible in any mode.
RUN
OK OK
Follow the procedure below to turn the key-input buzzer on and off.
1. Press the CLR, SHIFT, and then the CLR Key to bring up the mode display.
In this case the PC is in PROGRAM mode and the buzzer is ON.
CLR SHIFT
2. Press the SHIFT and then the 1 Key to turn off the buzzer.
B
SHIFT
3. Press the SHIFT and then the 1 Key again to turn the buzzer back ON.
B
SHIFT
This operation is used to display or change the expansion instructions
assigned to expansion instruction function codes. The assignments can be
displayed in any mode, but can be changed in PROGRAM mode only.
Operation
Read assignment OK
Change assignment No
Assign expansion instruction function codes before inputting the program. The
CPM2C-S will not operate properly if expansion instructions aren't assigned
correctly. An expansion instruction can be assigned to one function code only.
The PC Setup must be set for user-defined expansion instruction assign-
ments. Set bits 8 to 11 of DM 6602 to 1 and turn the PC's power off and then
on again to enable the new setting.
1. Press the CLR Key to bring up the initial display.
2. Press the EXT Key to display the assignment for the first function code
(17).
ERR/MSG CHK OK
MONITOR PROGRAM
OK
<MONITOR>
CLR
<MONITOR>
The buzzer will not sound
1
when "BZ" is not displayed.
<MONITOR>
1
RUN MONITOR
OK
No
INST TBL READ
FUN017:ASFT
EXT
Section 8-2
BZ
BZ
PROGRAM
OK
OK