Omron CPM2C-S100C Operation Manual page 115

SR Area
Word(s) Bit(s)
SR 252 00 High-speed Counter Reset Bit
01 to 03 Not used.
04 Pulse Output 0 PV Reset Bit
Turn ON to clear the PV of pulse output 0.
05 Pulse Output 1 PV Reset Bit
Turn ON to clear the PV of pulse output 1.
06, 07 Not used.
08 Peripheral Port Reset Bit
Turn ON to reset the peripheral port. Automatically turns OFF when reset is complete.
09 RS-232C Port Reset Bit
Turn ON to reset the RS-232C port. Automatically turns OFF when reset is complete.
10 PC Setup Reset Bit
Turn ON to initialize PC Setup (DM 6600 through DM 6655). Automatically turns OFF
again when reset is complete. Only effective if the PC is in PROGRAM mode.
11 Forced Status Hold Bit (See note.)
OFF: The forced status of bits that are forced set/reset is cleared when switching
ON: The status of bits that are forced set/reset are maintained when switching
The PC Setup can be set to maintain the status of this bit when the PC is turned off.
12 I/O Hold Bit (See note.)
OFF: IR and LR bits are reset when starting or stopping operation.
ON: IR and LR bit status is maintained when starting or stopping operation.
The PC Setup can be set to maintain the status of this bit when the PC is turned off.
13 Not used.
14 Error Log Reset Bit
Turn ON to clear error log. Automatically turns OFF again when operation is complete.
15 Not used.
between PROGRAM mode and MONITOR mode.
between PROGRAM mode and MONITOR mode.
Function
Section 4-4
Read/
write
Read/
write
Read/
write
Read/
write
Read/
write
93