Programming Console Operations; Overview - Omron CPM2C-S100C Operation Manual

Programming Console Operations

8-2

Programming Console Operations

8-2-1

Overview

Name
Clearing memory
Clearing all memory
Reading UM allocations
Reading/clearing error
messages
Buzzer operation
Assigning expansion
instruction function codes
Setting a program memory
address
Reading a program memory
address
Instruction search
Bit operand search
Inserting and deleting
instructions
Entering or editing programs
Checking the program
Bit, digit, word monitor
Multiple address monitor
Differentiation monitor
Binary monitor
3-word monitor
Signed decimal monitor
166
changed to RUN or MONITOR with the mode switch after entering the pass-
word.
CLR
MONTR
Indicates the mode set by the mode selector switch.
The following table lists the programming and monitoring operations that can
be performed from a Programming Console. Refer to the rest of this section
for details on operational procedures.
Clears all or part of the Program Memory and any data areas that are not
read-only, as well as the contents of the Programming Console's memory.
Clears the user program, including the I/O comment area set by the CX-Pro-
grammer (version 2.0 or later), as well as the PC Setup and all bits, timers,
counters, and DM Area data.
Reads the capacity of the I/O comment area and the ladder program when
an I/O comment area has been set with the CX-Programmer (version 2.0 or
later).
Displays and clears error messages and displays MESSAGE instruction
messages.
Turns on and off the buzzer that sounds when Programming Console keys
are pressed.
Reads or changes the function codes assigned to expansion instructions
Sets the specified program memory address when reading, writing, insert-
ing and deleting programs.
Reads the contents of the Program Memory. Displays the status of the cur-
rently displayed bit in PROGRAM and MONITOR modes.
Finds occurrences of the specified instruction in the program.
Finds occurrences of the specified operand bit in the program.
Inserts or deletes instructions from the program.
Overwrites the contents of the current Program Memory to either input a
program for the first time or to change a program that already exists.
Checks for programming errors and displays the program address and error
when errors are found.
Monitors the status of up to 16 bits and words, although only 3 can be
shown on the display at one time.
Monitors the status of up to 6 bits and words simultaneously.
Monitors the up or down differentiation status of a particular bit.
Monitors the ON/OFF status of any word's 16 bits.
Monitors the status of three consecutive words.
Converts the contents of the specified word from signed hexadecimal (two's
complement format) to signed decimal for display.
<PROGRAM>
PASSWORD!
<PROGRAM>
Function
Section 8-2
BZ
Page
167
168
168
169
170
170
171
171
175
176
176
172
178
179
180
181
182
182
183