Installing The Cpm2C-S; Connecting Units - Omron CPM2C-S100C Operation Manual

Installing the CPM2C-S

3-3

Installing the CPM2C-S

3-3-1

Connecting Units

1,2,3...
• Separate the CPM2C-S by at least 100 mm from other devices.
Other
device
100 mm min.
This section describes how to install the CPM2C-S and connect Expansion
Units and Expansion I/O Units. Refer to Appendix B for diagrams showing the
dimensions of the CPM2C-S CPU Units.
Note Refer to the CPM2C Programmable Controller Operation Manual for dimen-
sions of the Expansion I/O Units and Expansion Units.
Up to 3 Expansion I/O Units and Expansion Units can be connected to a
CPM2C-S CPU Unit. Use the following procedure when connecting an
Expansion I/O Unit or Expansion Unit.
1. Remove the cover from the CPU Unit's or the last Expansion I/O Unit's or
Expansion Unit's expansion I/O connector. If the cover is difficult to re-
move, use a flat-blade screwdriver to pry the cover from the expansion I/O
connector.
Section 3-3
Other
device
100 mm min.
Expansion I/O
connector cover
57