Rcu Battery Installation - Barco MCM-400 HFR User Manual

5. Physical installation and connections
5.1

RCU battery installation

Finding the batteries for the Remote Control Unit
The batteries are not placed in the remote control unit to avoid control operation in its package, resulting in a shorter battery life
time. At delivery the batteries can be found in a separated bag attached to the remote control unit. Before using your remote control,
install the batteries first.
Installing the batteries in the Remote Control Unit
1. Push the battery cover tab a little backwards (1) while pulling the cover upwards (2).
Image 5-1
2. Insert the two AA size batteries, making sure the polarities match the + and - marks inside the battery compartment.
Image 5-2
3. Insert (1) the lower tab of the battery cover in the gap at the bottom of the remote control, and press (2) the cover until it clicks
in place.
2
Image 5-3
To prevent battery explosion
• Danger of explosion if battery is incorrectly installed.
• Replace only with the same or equivalent type recommended by the manufacturer.
• Always replace both batteries at the same time.
• Never use an old and a new battery to together in the device.
• Disposal of used batteries must be done according to the manufacturer's instruction.
34
1
1
2
R5909056 MCM-400 HFR 11/05/2016