Barco MCM-400 HFR User Manual page 151

Expert use: automatically determining the common color values
1. Start up the Linked devices menu of the Master projector.
2. In the Linked devices menu press the Link Set 1 button.
Image 10-59
The common color values are automatically calculated based on the measured values of both devices and these calculated
values are put in the Desired values of both devices. Both devices will now operate within the same color gamut.
Dynacolor sets
If you use your projector(s) in different sceneries where different Dynacolor sets are used, like Set 1 or Set 2 or Infitec Set, you need
to perform the Dynacolor adjustment (i.e. Color fine tuning, Calculating common triangles) for each of the Sets.
Activate a scenery and align the colors. Then activate another scenery for which another Dynacolor set is used and again align the
colors.
Selecting a Dynacolor set
1. In the OSD, navigate to Display setup > Dynacolor > Active Set and select the Dynacolor set you want to become active (Set 1,
Set 2 or Infitec set).
R5909056 MCM-400 HFR 11/05/2016
10. Expert operation
147