The Dynacolor Dialog - Barco MCM-400 HFR User Manual

10.3.2 The Dynacolor dialog

Description
In the OSD, browse to Display setup > Dynacolor > Edit... and press ENTER to display the Dynacolor dialog. The tables below
explain all items of this dialog.
Field / item
Measured values
X and Y coordinates
Red, Green, Blue, White
L value
White L
Desired values
Desired values
X and Y coordinates
Red, Green, Blue, White
Cyan, Yellow, Magenta
L value
Lmax value
Button
Default desired
Factory Preset
Calibration
R5909056 MCM-400 HFR 11/05/2016
Description
The coordinates in the CIE Chromaticity diagram and luminance of the native
primary colors of the projector as they have been measured in ideal conditions in
the factory. Only Barco engineers may change these values.
Coordinates in the CIE Chromaticity diagram
Native primary colors and native white of the projector
Luminance (relative value)
White luminance = Red + Blue + Green luminance (relative value)
Description
The coordinates in the CIE Chromaticity diagram and luminance of the desired
primary and secondary colors of the projector. Only Barco engineers may
change these values to force a common color triangle; Barco trained and
qualified engineers may also change the X and Y coordinates of the white
point to fine tune the colors.
Coordinates in the CIE Chromaticity diagram
Desired primary colors and desired white of the projector
Desired secondary colors of the projector
Luminance (relative value)
Maximum available luminance (relative value)
Description
Resets the desired parameters to the measured values.
Sets the measured parameters back to the factory preset values.
Starts the native primary color calibration procedure. Only Barco engineers may
perform a calibration. A professional spectrometer and ideal measurement
conditions are required to achieve a good calibration. Improper calibration seriously
affects the performance of the projector. See procedure "Color calibration", page
155.
10. Expert operation
149