Barco MCM-400 HFR User Manual page 28

2. Introduction
• 1. Power input : to connect the power adaptor, which is delivered with the device.
• 2. Fuse : input fuse.
• 3. Debug port : to debug if necessary (by a qualified technician only).
• 4. IR receiver : receives IR commands from the RCU.
• 5. RJ 45 connector : to connect TCP/IP.
• 6. Stereo sync out : to drive emitters or for linking (not supported).
• 7. USB port : not supported.
• 8. Stereo input : to connect stereo control signals.
• 9. DisplayPort input : to connect DisplayPort sources.
• 10. Stereo input : to connect stereo control signals.
• 11. DisplayPort input : to connect DisplayPort sources.
• 12. Stereo input : to connect stereo control signals.
• 13. DisplayPort input : to connect DisplayPort sources.
• 14. Stereo input : to connect stereo control signals.
• 15. DisplayPort input : to connect DisplayPort sources.
• 16. DisplayPort out : Output only active when a Barco Galaxy 4K projector is detected on the network (correct IP-address
needs to be available)
• 17. DisplayPort out : Output only active when a Barco Galaxy 4K projector is detected on the network (correct IP-address
needs to be available)
Remote Control Unit
Image 2-3
Remote Control unit
Use the Remote Control Unit (RCU) to operate the device through the OSD (On Screen Display).
24 R5909056 MCM-400 HFR 11/05/2016