Moving An Anchor Point In Large Steps - Barco MCM-400 HFR User Manual

9.1.8

Moving an anchor point in large steps

Description
Edit Mode enables you to select the PixelsX or PixelsY edit box whereas in Change Mode you can edit the value of the selected
PixelsX (i.e. relative movement along the X-axis; can be negative) or PixelsY (i.e. relative movement along the Y-axis; can be
negative).
Editing the values of X and Y coordinates
1. In the Geometry edit dialog, navigate to Edit Mode by pressing ENTER.
2. Press ▲ or ▼ to select the edit box of PixelsX or the edit box of PixelsY.
Image 9-17
3. Press ENTER to select Change Mode.
The selected (PixelsX or PixelsY) edit box is highlighted.
4. Enter a new value.
Image 9-18
R5909056 MCM-400 HFR 11/05/2016
9. Advanced operation
105