Network Connection - Barco MCM-400 HFR User Manual

5. Physical installation and connections
5.7

Network connection

What can be done ?
The device can be connected to a network allowing it to be accessed from any connected network device. The Ethernet connection
can be used to upload/download device software and/or to set up communication (TCP-packets) with the device. This network can
be a local area network or a small dedicated network.
Following operations are made possible :
• file transfer for firmware upgrade
• storage of multiple device configurations and set ups
• wide range of control possibilities
• linking the devices to allow uniform color (Linked Dynacolor).
• ...
The connection to the device can be done via a crossed cable or via a switch on the local network (LAN).
Connecting the device to a network
1. Connect the RJ 45 male plug to the device's RJ 45 female connector.
Image 5-10
Ethernet connection
See Network settings to set the communication port.
The linking of devices is treated in the section "Setup of the linked devices in a multichannel system".
40 R5909056 MCM-400 HFR 11/05/2016