Beta Planes - Barco MCM-400 HFR User Manual

10.2.5 Beta planes

Uploading a Beta plane file
Use an FTP Client (e.g. Filezilla) to upload the Beta plane to the following directory on the MCM-400 HFR:
/D/Display/Softedge
The file must be named as follows :
beta.tiff
The free storage capacity on the D-drive is about 8 MB. it is needed to store the image files, geometry files, factory backup, Alpha
planes and Beta planes. In practice, about 6 MB is available for the Alpha + Beta plane.
Uploading and activating an external Beta Plane
1. Make sure that the computer from where you want to upload the external Beta Plane is in the same network as the projector.
2. Open your Internet Browser and browse to the projector using FTP: e.g. ftp://<Hostname>.
3. Copy and paste the external Beta Plane in the following folder on the device's flash: D:/Display/Softedge.
4. Browse to Display setup > Soft-edge and alpha beta planes > Black level... and press ENTER to open the Black level dialog.
Image 10-43
5. In the Planes section of the Black level dialog, set checkbox Beta plane.
Image 10-44
6. Exit the menu.
R5909056 MCM-400 HFR 11/05/2016
10. Expert operation
135