Selecting An Anchor Point - Barco MCM-400 HFR User Manual

10. Expert operation

10.2.8 Selecting an anchor point

Description
In Select mode, you can select any of the anchor points. You cannot adjust or edit the selected anchor point in this mode. All actions
that can be performed in Select mode are explained in the Help section of the Soft Edge edit dialog.
Selecting an anchor point
1. Open the Soft Edge edit dialog by clicking Adjust in the Soft Edge selection dialog.
Image 10-51
2. Use the arrow keys ◄ and ► on the RCU to select another anchor point in the same level.
3. Use the arrow key ▲ on the RCU to go to a higher level. If you are at Level 1, pressing ▲ activates the first anchor point on the
next edge of the image.
4. Use the arrow key ▼ on the RCU to go to a lower level. If you are at the lowest level in your selection (see the setting in the Soft
Edge selection dialog), pressing ▼ activates the first anchor point on the previous edge of the image.
5. If the correct anchor point is selected (indicated by a red square around it), press ENTER to go to Adjust mode or press BACK
to return to the Soft Edge selection dialog.
140 R5909056 MCM-400 HFR 11/05/2016