Moving An Anchor Point In Small Steps - Barco MCM-400 HFR User Manual

9. Advanced operation
9.1.7

Moving an anchor point in small steps

Description
Adjust mode is used to do small geometry adjustments using the arrow keys on the RCU. Each step is only 1/32 of a pixel. For
larger adjustments the Adjust mode is not the ideal method. In that case the use of the Edit mode and Change mode is advised.
The steps below explain the procedure to adjust the anchor point on (row 0, column 0) along the X axis in 2x2 mode.
Using the arrow keys to move an anchor point
1. After selecting the anchor point in Select mode, press ENTER to switch to Adjust Mode.
Image 9-15
2. Press ◄ and ► a multiple times or keep the arrow pressed to move the anchor point along the X-axis.
Also notice the impact of moving a top level anchor point in the example below.
Image 9-16
Adjusting the PixelsX and PixelsY positions
3. Press ▲ and ▼ a multiple times or keep the arrow pressed to move the anchor point along the Y-axis.
104 R5909056 MCM-400 HFR 11/05/2016