Displaying A Single Source - Barco MCM-400 HFR User Manual

7.2

Displaying a single source

Description
Before a source can be projected, the source signal must be connected to the source input(s) of the device and a valid synchroniza-
tion signal must be available along with the source signal on at least one of the input connectors.
How to select a source from OSD?
1. In the OSD, navigate to Source selection and open the drop down menu.
2. Select the source to be displayed.
Image 7-1
3. Press ENTER to display the selected source.
An available source is indicated by a Barco logo
in the prefix.
W
ARNING
output is disabled.
R5909056 MCM-400 HFR 11/05/2016
:
Check the connection with the display! If this connection is not established, the MCM-400 HFR
in the prefix. A displayed source is indicated by a bullet
7. Getting started
61