Color Fine Tuning - Barco MCM-400 HFR User Manual

10. Expert operation
10.3.4 Color fine tuning
C
AUTION
Single channel setup
Each projector is color calibrated during production. This means that devices in single channel setup need no color fine tuning.
However to switch to a different color reproduction or color temperature, the color coordinates of the white point (W) can be changed
in the active Dynacolor set.
Multiple channel setup
In a multiple channel setup, it might be needed to match the colors amongst all devices. To do so, the color coordinates for a
common color triangle are calculated from the native (i.e. measured) color coordinates for R, G, B and W of each projector and
entered as desired coordinates in the appropriate Dynacolor set. After applying a common triangle, some final color fine tuning might
be required to come to a fully color matched overall image.
Fine tuning the color of the projected image
1. Check to see what Dynacolor Set is currently active: Display setup > Dynacolor > Active set: the set that has the radio button is
the active set.
2. In the OSD, navigate to the active Dynacolor set: Display setup > Dynacolor > Adjust set > Set 1... or Set 2... or .....
Image 10-63
3. Press ENTER to confirm your selection.
In this case, we have used Set 1.
4. In the Dynacolor Set 1 dialog, enter a well-considered new value for X and/or Y of White.
152
:
Color fine tuning may only be done by Barco trained and qualified engineers.
R5909056 MCM-400 HFR 11/05/2016