Using Dynacolor Sets - Barco MCM-400 HFR User Manual

9. Advanced operation
9.2

Using Dynacolor sets

To apply the color corrections previously saved in a Dynacolor set, make sure that Dynacolor is enabled.
Description
Depending on the device parameters and options, different Dynacolor sets can and will be used when Dynacolor is enabled.
The following three Dynacolor sets can be selected and defined:
• Set 1: standard Dynacolor set, can be selected if the (optional) Infitec filter in the projector is not inserted;
• Set 2: standard Dynacolor set, can be selected if the (optional) Infitec filter in the projector is not inserted;
• Infitec set: Dynacolor set with advanced color tracking — should be selected when the optional Infitec filter in the projector is
inserted;
How to select a Dynacolor set?
1. In the OSD, navigate to Display setup > Dynacolor > Active set > Set 1, Set 2 or Infitec set.
Image 9-22
2. Press ENTER to select.
To know about Dynacolor adjustments for various sets defined, please see the Expert operation chapter.
108 R5909056 MCM-400 HFR 11/05/2016