Barco MCM-400 HFR User Manual page 136

10. Expert operation
Image 10-37
3. Click Adjust to open the Soft Edge Edit dialog.
Image 10-38
4. Select one of the edges where blanking is required. See "Selecting an anchor point", page 140.
5. Select Level 1. See "Selecting an anchor point", page 140.
6. Adjust the position of anchor points zero and four. See "Selecting an anchor point", page 140, "Moving an anchor point in small
steps", page 141 and "Moving an anchor point in large steps", page 142.
7. If you need to further shape the blanking area on the selected side, proceed to Level 2. See "Selecting an anchor point", page
140.
8. Adjust the position of anchor point two if required. See "Selecting an anchor point", page 140, "Moving an anchor point in small
steps", page 141 and "Moving an anchor point in large steps", page 142.
9. If you need to further shape the blanking area on the selected side, proceed to Level 3. See "Selecting an anchor point", page
140.
10.Adjust the position of anchor points one and three if required. See "Selecting an anchor point", page 140, "Moving an anchor
point in small steps", page 141 and "Moving an anchor point in large steps", page 142.
11. Exit the menu.
Adjusting Black Level
1. Project a full black image.
2. Activate the created Soft Edge. See "The Soft Edge selection dialog", page 136: set checkbox Internal.
3. Browse to Display setup > Soft-edge and alpha beta planes > Black level... and press ENTER to open the Black level dialog.
132 R5909056 MCM-400 HFR 11/05/2016