General Soft Edge Workflow - Barco MCM-400 HFR User Manual

10. Expert operation
10.2.3 General Soft Edge workflow
Introduction
Before you start creating a Soft Edge, make sure that geometry (Geometry adjustment), colors (Dynacolor) and brightness (CLO,
TOD) are perfectly aligned amongst all devices.
Creating a Soft Edge
1. In the OSD, browse to Display setup > Soft-edge and alpha beta planes > Edit... and press ENTER to open the Soft Edge
Selection dialog.
Image 10-33
2. In the Soft Edge Selection dialog, enter the following selections:
- Plane: set checkbox Internal;
- Source: click Full white;
- Edges: set the check boxes of the edges where you want to create a Soft Edge;
- Adjustment guide: click On;
- Hierarchy levels: select the lowest level you expect to need.
Image 10-34
3. Click Adjust to open the Soft Edge Edit dialog.
130 R5909056 MCM-400 HFR 11/05/2016