Moving An Anchor Point In Large Steps - Barco MCM-400 HFR User Manual

10. Expert operation

10.2.10 Moving an anchor point in large steps

Description
Edit Mode enables you to select the Position X or Position Y edit box whereas in Change Mode you can edit the value of the selected
Position X (i.e. relative movement along the X-axis; can be negative) or Position Y (i.e. relative movement along the Y-axis; can be
negative). The actions that can be performed in Edit mode and in Change mode are explained in the Help section of the Soft Edge
edit dialog.
Editing the values of Position X or Position Y
1. From the Soft Edge edit dialog, press ENTER or BACK to navigate to Edit mode.
Image 10-53
2. Use the arrows ▲ or ▼ to select the Position X or Position Y edit box.
3. Press ENTER
to navigate to Change mode.
Image 10-54
The selected (Position X or Position Y) edit box is highlighted.
4. Enter a new value.
142 R5909056 MCM-400 HFR 11/05/2016