Connecting The Galaxy 4K Hfr Or Hdq-4K40 Series Projector - Barco MCM-400 HFR User Manual

5. Physical installation and connections
5.5

Connecting the Galaxy 4K HFR or HDQ-4K40 series projector

Description
The signal from the MCM-400 HFR to the external Galaxy 4K HFR or HDQ-4K40 series projector is digital only. It is transmitted
using DisplayPort cables. For specifications, see the concerning appendix.
The MCM-400 HFR should always be connected to the Barco Galaxy 4K HFR or HDQ-4K40 series projector.
Connecting the Barco Galaxy 4K HFR or HDQ-4K40 series projector
1. Connect one end of the DisplayPort cables to the DP output connector on the rear side of the MCM-400 HFR.
2. Connect the other end of the DisplayPort cables to the DP input connector of the Galaxy 4K HFR or HDQ-4K40 series projector.
- resolution: the output resolution of the MCM-400 HFR depends on the output mode which can be set in the OSD (Navigate
to Display setup > Stereo mode).
- vertical refresh rate in all modes (mono, passive stereo & active stereo):
Synchronous : 23.5Hz - 60.5Hz
o
Asynchronous : 60Hz
o
- signal type: DisplayPort.
6
LAN
Image 5-8
DisplayPort cable for channel A between MCM-400 HFR and Galaxy 4K HFR or HDQ-4K40 series projector.
3
4 DisplayPort cable for channel B between MCM-400 HFR and Galaxy 4K HFR or HDQ-4K40 series projector.
6 Network connections (LAN) : is needed to enable the MCM-400 output!
38
3 4
R5909056 MCM-400 HFR 11/05/2016
DP A DP B