Barco MCM-400 HFR User Manual page 59

Image 6-17
Note: To clear an IP address or Host name from the edit box, click the C button.
4. Set the Dynacolor checkbox if the color settings of the Slave MCM-400 HFR should be controlled by the master during color
alignment.
5. Set the CLO checkbox if the CLO of the Slave projector should be controlled by the master.
Setting an MCM-400 HFR to be Slave
1. In the OSD of the MCM-400 HFRs to be Slave, navigate to Installation > Linked devices... and press ENTER to select.
Image 6-18
2. In the dialog box that appears, clear the Master check box.
R5909056 MCM-400 HFR 11/05/2016
6. Setup and configuration
55