Selecting An Anchor Point - Barco MCM-400 HFR User Manual

9. Advanced operation
9.1.6

Selecting an anchor point

Description
In Select Mode, you can select any of the anchor points of the selected level and of the higher levels. You cannot adjust or edit the
selected anchor point in this mode.
Selecting an anchor point
1. After selecting the level from the Geometry Distortion edit dialog, by default, Select Mode is enabled and the top/left (row = 0 ;
column = 0) corner is selected.
Image 9-12
Selection: Row 0; Column 0
2. Use the arrow keys on the RCU (►, ▼, ◄ and ▲) to select the another adjustment point.
E.g. In 3 x 3 mode, ► would jump to column 15, row 0. In 2 x 2 mode, ► would jump to column 32, row 0. See image below.
Image 9-13
Selection: Row 0; Column 32
102 R5909056 MCM-400 HFR 11/05/2016