GE VersaMax Manual page 340

Module Specifications
Module Characteristics
Channels
Module ID
Isolation:
User input to logic (optical) and to
frame ground
Group to group
Channel to channel
LED indicators
Backplane current consumption
External power supply
Thermal derating
Configuration parameters
Diagnostics
Input Characteristics
Input current
Input Impedance
Accuracy at:
Resolution
Filter response (3dB Corner Freq)
Update rate per module
Compatibility
VersaPro Software
VersaMax PLC CPU Firmware
VersaMax Ethernet NIU Firmware
VersaMax DeviceNet, Profibus, or
Genius NIU Firmware
* In the presence of severe RF interference, (IEC 1000-4-3, 10V/m), accuracy may be degraded to +/-2%.
GFK-1504K Chapter 10 Analog Input Modules
Analog Input Module, 15 Bit Current 15 Channels
25 degrees C*
0 to 60 degrees C
( See Notes 1, 2, & 3 )
15 single ended, one group
FFFFB50F (when cfg for 4-20mA range)
FFFFB40F (when cfg for 0-20mA range)
250VAC continuous; 1500VAC for 1 minute
Not applicable
None
OK LED. See "LED Indicators" for description.
5V output: 100mA maximum
None
None
Range select (jumpers on carrier)
Loss of Internal Power, Open wire detection of 4-20mA
signals only
4 to 20mA (default : no terminal jumper installed)
0 to 20mA (with terminal jumper installed)
100 Ohms
+/-0.3% typical of full scale, +/-0.5% maximum of full
scale
+/-1% maximum of full scale
15 bits
0.5µA = 1 counts (for 4-20mA range)
0.625µA = 1 counts (for 0-20mA range)
24 Hz +/-20%
7.5ms
Version 2.0 or higher
Version 2.10 or higher
Version 1.10 or higher
Planned for future release
10
IC200ALG264
10-43