GE VersaMax Manual page 327

10
IC200ALG262
Analog Input Module, 15 Bit Differential Current 8 Channels
Module Specifications
Module Characteristics
Channels
Module ID
Isolation:
User input to logic (optical) and to
frame ground
Group to group
Channel to channel
LED indicators
Backplane current consumption
External power supply
Thermal derating
Configuration parameters
Diagnostics
Input Characteristics
Input current
Common Mode Range
Common mode rejection
Input Impedance
Accuracy (0V Common Mode):
Resolution
Update rate per module
Compatibility
VersaPro Software
VersaMax PLC CPU Firmware
VersaMax Ethernet NIU Firmware
VersaMax DeviceNet, Profibus, or
Genius NIU Firmware
*
In the presence of severe RF interference, (IEC 1000-4-3, 10V/m), accuracy may be degraded to +/-1%. Input
accuracy may be degraded an additional +/-3% with the introduction of input common mode voltage.
10-30 VersaMax® Modules, Power Supplies, and Carriers User's Manual – March 2003
25 degrees C*
0 to 60 degrees C
8 differential, one group
FFFFB508 (when configured for 4-20mA range)
FFFFB408 (when configured for 0-20mA range)
250VAC continuous; 1500VAC for 1 minute
Not applicable
None
OK LED indicates backplane power is present
5V output: 200mA maximum
None
None
Range select (jumpers on carrier)
Loss of Internal Power, Open wire detection of 4-20mA
signals only
4 to 20mA (default : no terminal jumper installed)
0 to 20mA (with terminal jumper installed)
-10V to +10V
70db
100 Ohms
+/-0.3% typical of full scale, +/-0.5% maximum of full scale
+/-1% maximum of full scale
0.5µA = 1 counts (for 4-20mA range)
0.625µA = 1 counts (for 0-20mA range)
7.5ms
Version 2.0 or higher
Version 2.10 or higher
Version 1.10 or higher
Planned for future release
GFK-1504K