Wiring For A Barrier-Style I/O Carrier; Terminal Numbering For A Barrier-Style I/O Carrier - GE VersaMax Manual

Wiring for a Barrier-Style I/O Carrier (IC200CHS001)
Field Wiring
Terminals
Each terminal on a Barrier-Style I/O Carrier accommodates one or two solid or stranded
wires from AWG #22 (avg. 0.36mm
section). Use copper wire rated for 90 degrees C. When inserting two wires in the same
position, the wires must be the same size and type (solid or stranded).
The I/O carrier can accommodate current levels up to 2 Amps per point or 8 Amps per
each power and ground, and a voltage range of up to 264 VAC. Voltage transients up to
300 VAC will not damage the carrier.
For a Barrier-Style I/O Carrier, recommended terminal torque is .37 to .50 ft-lbs.
The label provided with the module can be folded and inserted in the module's transparent
door.

Terminal Numbering for a Barrier-Style I/O Carrier

GFK-1504K Chapter 2 Installation Instructions
H B 8 2
G
C 7 3
4
D
6
F
2
cross section) to AWG #14 (avg. 2.1mm
A13 A15 A16 A17 A18
A14
A7 A8 A9 A11 A12
A10
A1 A2 A3 A4 A5 A6
B13 B15 B16 B17 B18
B14
B7 B8 B9 B11 B12
B10
B1 B2 B3 B4 B5 B6
2
2
cross
2-19