Installing And Removing A Prewired Cable; Connector Kit; Terminal Numbering - GE VersaMax Manual

Installing and Removing a Prewired Cable

To install a prewired connecting cable, place the cable connector over the connector on the
carrier and press downward until the latch engages the tab on the connector. (If you have
an IC200CBLxxx cable with a non-molded style connector, please turn to appendix E for
installation and removal instructions).
To remove the cable, hold the cable connector and press up on the latch to release the
connector. When removing the cable, remember that operating equipment may be very hot,
especially at higher ambient temperatures. If the equipment is hot, do not touch it directly.
DO NOT TOUCH exposed connector pins if the system is operating.

Connector Kit

A connector kit (part number IC200ACC304) is available for building custom cables or for
connecting wires directly from field devices. The kit includes a connector and cover, two
screws, 36 small contacts, and 6 large contacts. The following equipment is also required
but not included in the kit:
Crimping Tools
Extraction Tools

Terminal Numbering

The illustration below shows the terminal assignments of the connector pins as viewed
from above.
GFK-1504K Chapter 2 Installation Instructions
small contact
large contact
small contact
large contact
A terminals
B5 B6
A1 A2 A3 A4 A5
A17
A6 A7 A8 A9 A10 B12 B9
A18
A11 A12 A13 A15 A16 B15
A14
Cable
Cable
Latch
Molex 11-01-0008
Molex 11-01-0084
Molex 11-03-0002
Molex 11-03-0006
B terminals
B3 B4 B1 B2
B17
B10 B7 B8
B18
B16 B13 B14 B11
2
2-21