Xerox DocuColor 2240 Service Manual page 1251

Figure 5 Token Ring PWB
23. The LED indicates a successful network connection. If the LED is off, call for network
assistance.
Installation
Token Ring Installation, Foreign Interface Installation
Green LED
Foreign Interface Installation
Purpose
The purpose of this kit is install a plug and play foreign interface accessory that will enable the
customer to attach a third-party vending device such as a debit machine or an external
auditron machine.
Kit Contents
Check the kit contents against the following list:
1. Foreign Interface
2. Kit Instructions
Prerequisites
NOTE: The TAG P2 prerequisite applies to DC 2240/1632 machines only.
The Foreign Interface kit requires machine S/W level 4.1 or higher (TAG P2). If Tag P2 or
higher software is not installed, use the CD to download the software (follow the instructions on
the CD), then mark off Tag 2 on the IOT Tag Matrix.
Ensure that the machine is fully operational.
Procedure
1. Switch off the machine and unplug the power cord(s) from the wall outlet.
2. On the rear of the machine:
a. Loosen the screw (Figure
b. Rotate the cover (Figure
c. Secure the cover by tightening the screw.
d. Ensure that the connector is completely exposed.
Figure 1 Cover on Rear of Machine
02/03
9-6
1).
1).
Screw
Cover
DC 3535/2240/1632
Initial issue