Output Configuration Menu - Extron electronics MediaPort 200 User Manual

If HDCP Authorized is disabled and HDCP protected content is selected for the source, the
source either mutes its video output to black or displays a warning message.
HDCP Authorized can also be adjusted using via the PCS control software (see the
MediaPort 200 Help file) or SIS commands (see
an HDCP Authorized Device

Output Configuration Menu

The
Output Configuration
resolution and rate, configures the HDMI loop output, and enables or disables the HDCP
notification. Figure 71 below gives an overview of this menu.
Input
Configuration
Menu
Output
Configuration
Next
Figure 71.
• USB Format — Select the USB video output streaming format. Rotate either
knob to select between the following formats:
•
MJPEG 422 Full
•
MJPEG 422 Limited
on page 123).
menu shows the current USB audio and video streaming
USB Format
Next
MJPEG 422 Full
Select the USB output
streaming format.
• MJPEG 422 Full (Default)
• MJPEG 422 Limited
• MJPEG 420 Full
• MJPEG 420 Limited
HDCP Note
On
Display or hide the green
HDCP notification screen.
On (Default)
•
Out
•
Output Configuration Menu
(default)
HDCP Authorized — Input Reporting as
Resolution Group
Next
All
Select the USB output
streaming resolution group.
All (Default)
•
Low
•
Medium
•
• High
HDMI Loop Format
Next
Auto
Select the HDMI loop output
format.
• Auto (Default)*
• DVI RGB 444
• RGB 444 Full
• RGB 444 Limited
• YUV 444 Full
• YUV 444 Limited
• YUV 422 Full
• YUV 422 Limited
*Auto outputs DVI to a DVI sink and
HDMI RGB 444 Full to an HDMI sink.
•
MJPEG 420 Full
•
MJPEG 420 Limited
MediaPort 200 • Front Panel Operation
Next
Adjust
73