Extron electronics MediaPort 200 User Manual page 78

In follow mode, each input rate is displayed with its native aspect ratio (4:3, 5:4,
•
15:9, 16:9, 16:10) with the correct letterbox or pillar box settings, visible in the
and screens of the
Position
For specific input or image raster to fill the screen in follow mode, manually set the
item on the
Position
the current output rate
NOTE: In follow mode, the MediaPort calculates the aspect ratio at the point
the signal is applied. If the image size or position is changed via the
menu, the aspect ratio of the image may no longer match the native
Control
aspect ratio of the input signal. To resize and re-center the image, perform an
Auto-Image (see
Auto Memory — Enables and disables Auto Memory. Auto Memories store the details
•
of an input signal in scaling bridge memory, so that the unit applies the appropriate
settings when it detects that signal again (see
either knob to set Auto Memory to
Adjust
• HDCP Authorized — Disable HDCP communication by causing the MediaPort
HDMI input to report to a source device as a non-authorized HDCP sink (see
Authorized on the next page). Rotate either
. The default is
Disabled
Selecting an input EDID
To select a resolution and rate for input emulation:
1. Select
HDMI Input EDID
2. Rotate the left
Adjust
refresh rate.
3.
Press or wait until the LCD screen times out to the default cycle (approximately
Next
30 seconds). The selection is saved and appears next time the
screen is accessed.
Picture Controls
menu to
Picture Controls
, .
X Y
Performing Auto-Image
Auto Memories
(the default) and
On
Adjust
.
Disabled
from the
Input Configuration
knob to select the resolution and the right knob to select the
MediaPort 200 • Front Panel Operation
menu.
, and set the to match
0 0 Size
Picture
on page 66).
on page 82). Rotate
.
Off
HDCP
knob to select or
Enabled
menu.
HDMI Input EDID
Size
71