Application 2 - Mediaport 200 With External Dsp With Aec With Hardware And Software Codecs - Extron electronics MediaPort 200 User Manual

Application 2 — MediaPort 200 with External DSP with AEC with Hardware
and Software Codecs
NOTE: Ensure that the MediaPort 200 is set to External DSP with AEC audio mode
in PCS before beginning setup (see
information about selecting Standalone audio mode).
This is an application for soft codec conferencing in a room that also has a hardware
video codec and a DSP that adds multiple microphones with distributed AEC. Software
or hardware conferencing can be used independently at any time, or both simultaneously,
bridging both hardware and software codecs into the same conference.
100-240V ~ 0.7A MAX 1 2 3
MIC +48V
1 2 3 4 5 6 7
50/60 Hz 5 6 7 8
DMP 128 C AT
MediaPort 200
POWER STANDBY
HD Camera
Figure 86.
1 2
OVER
TEMP
LIMITER/PROTECT
SIGNAL
XPA 1002
XPA 1002
4 9 10 DMP 128 C AT 1 2 3 4
1 2 3 4 5 G 6 7 8 9 10 G
1 2
8 11 12 5 6 7 8
RS-232
11 12 13 14 15 G 16 17 18 19 20 G Tx Rx G EXP
100-240V - - A MAX
HDMI
AEC AUX
USB
L LINE R MIC/LINE L LINE R
LOOP OUT
+48V
INPUT OUTPUT
50/60 Hz
iPod 9:45 AM
iPod
Application 2 — MediaPort 200 with Hardware and Software Codecs
and a DSP
MediaPort 200 • with External DSP with AEC Application Setup
General Settings Tab on page 59 for more
Audio
'
3 4
RESET
LAN
I1 I2 G O1 O2
I/O
LAN
RS-232 +12V
RESET
Tx Rx G
0.1A
MAX
REMOTE
Video/Audio
Table Microphones
PC
HDMI DA
Video Codec
Display
102