Input Configuration Menu - Extron electronics MediaPort 200 User Manual

Input Configuration Menu

The
Input Configuration
horizontal and vertical
below shows the selections available from this menu.
Configuration
HDMI Input EDID
Next
Select an EDID for the HDMI input.
• Default: 720p@60Hz
• See the Input EDID table on
page 73 for available EDIDs.
Figure 70.
The following items are available on the
• HDMI Input EDID — Select an EDID (resolution and refresh rate) emulation for the
HDMI input (see the
Rotate the left
refresh rate. The default is
NOTE: All factory-provided EDIDs are in HDMI, LPCM-2ch format. If DVI format is
required, use a custom EDID.
Active Pixels and Lines — (Read only) View the amount of lines and pixels that
•
constitute the active area of the image for the current HDMI input. On the LCD screen,
active pixels are displayed under
Aspect Ratio — Specify aspect ratio handling of the HDMI input. Rotate either
•
knob to select
the input). The default is
In fill mode, to set an aspect ratio adjustment for a single input rate, select the
•
correct size and position manually from the
Position screens
menu enables adjustments to the input signal. Rotate the
knobs to set the values for the current selection. Figure 70
Adjust
Picture
Control
Menu
Input Turn either
Adjust
to select a setting.
Next
H
Next
720p@60Hz
View the active lines and pixels for the input.
Active Pixels (H)
HDCP Authorized
Disabled
Enable or disable HDCP authorization.
Enabled
•
• Disabled (Default)
Input Configuration Menu
Input EDID Table
knob to select the resolution and the right knob to select the
Adjust
720p @ 60 Hz
H
(fills the entire screen) or
Fill
.
Fill
Picture Control Menu
) (see
knob
Active V
Next
1024 0768
Active Lines (V)
Auto Memory
Next
On
Enable or disable Auto Memory.
On (Default)
•
• Off
menu:
Input Configuration
on page 72 for a list of the available EDIDs).
.
and active lines under .
V
(displays with the aspect ratio of
Follow
Picture Controls
on page 68).
MediaPort 200 • Front Panel Operation
Aspect Ratio
Fill
Next
Specify how much of the
display the image will fill.
Fill (Default)
•
Follow
•
Adjust
menu ( and
Size
70