Extron electronics MediaPort 200 User Manual page 143

Command
Set IP address
14, 24
NOTES:
• Attempting to set the IP address, subnet mask, or gateway address while DHCP is on results in an
error message. After any IP setting adjustment is made,
• The Restart Network command must be entered (see
View IP address
View hardware (MAC)
address
Set subnet mask
View subnet mask
Set gateway IP address
View gateway IP
address
View connections listing
NOTES:
X7$ = IP address (nnn.nnn.nnn.nnn). Leading zeros in each of the four fields are optional in
setting values and are suppressed in returned values.
Factory default address (when DHCP is turned off) is
X7% = Subnet mask (nnn.nnn.nnn.nnn). Leading zeros are optional in setting values in each
of the four fields, and are suppressed in returned values.
X8# = Hardware (MAC) address (xx-xx-xx-xx-xx-xx)
ASCII Command
(host to unit)
E X7$ }
CI
E }
CI
E }
CH
E X7% }
CS
E }
CS
E X7$ }
CG
E }
CG
E }
CC
Response
(unit to host)
• X7$]
Ipi
Reset on page 132).
X7$]
With tagged responses
(verbose modes 2 and 3):
X7$]
Ipi
X8#]
With tagged responses
(verbose modes 2 and 3):
X8#]
Iph
• X7%]
Ips
X7%]
With tagged responses
(verbose modes 2 and 3):
X7%]
Ips
• X7$]
Ipg
X7$]
With tagged responses
(verbose modes 2 and 3):
• X7%]
Ipg
{number of
]
connections}
With tagged responses
(verbose modes 2 and 3):
Icc {number of
]
connections}
192.168.254.254
MediaPort 200 • Remote Configuration and Control
Additional Description
E14
.
136