Output Configuration Menu - Extron electronics MediaPort 200 User Manual

Hdmi and audio to usb scaling bridge
Hide thumbs Also See for MediaPort 200:
Table of Contents

Advertisement

If HDCP Authorized is disabled and HDCP protected content is selected for the source, the
source either mutes its video output to black or displays a warning message.
HDCP Authorized can be adjusted using via the PCS control software (see the MediaPort
200 Help file) or SIS commands (see

Output Configuration Menu

The
Output Configuration
resolution and rate, configure the HDMI loop output, and enable or disable the HDCP
notification. Figure 71 below gives an overview of this menu.
NOTE: The streaming USB video resolution output from the MediaPort 200 is
determined by the host UC software based on available PC resources and network
conditions. See
TIP: The size of the far end UC application window affects the streaming USB video
resolution and should be maximized for the highest resolution.
Input
Configuration
Menu
Output
Configuration
Next
HDCP Note
On
Display or hide the green
HDCP notification screen.
On (Default)
Out
Figure 71.
USB Video Send — (View only) Displays the streaming resolution and refresh rate of
the current USB video output.
USB Audio Send — (View only) Displays the audio stream from USB, (always
24-bit @48 kHz
USB Format — Select the USB video output streaming format. Rotate either
knob to select between
HDMI Loop Format — Select the digital format of the HDMI loop output. HDMI, DVI,
or YUV video formats can be selected. Any DVI or HDMI video format can be discretely
forced.
HDCP Authorized
menu shows the current USB audio and video streaming
USB Video
on page 5 for more information.
USB Video Send
Next
None
HDMI Loop Format
Next
Auto
Select the HDMI loop output
format.
Auto (Default)*
DVI RGB 444
RGB 444 Full
RGB 444 Limited
YUV 444 Full
YUV 444 Limited
YUV 422 Full
YUV 422 Limited
*Auto outputs DVI to a DVI sink and
HDMI RGB 444 Full to an HDMI sink.
Output Configuration Menu
), if audio is being sent.
MJPEG 422 Full
on page 119).
USB Audio Send
Next
24-bit @48 kHz
USB Format
Next
MJPEG 422 Full
Select the USB output
streaming format.
MJPEG 422 Full (Default)
MJPEG 420 Full
(the default) and
MJPEG 420 Full
MediaPort 200 • Front Panel Operation
Next
Adjust
.
73

Advertisement

Table of Contents
loading

Table of Contents