Edit Comm Settings Menu - Extron electronics MediaPort 200 User Manual

Edit Comm Settings Menu

The
Edit Comm Settings
Any changes to communication settings must be made from this menu.
Accessing the Edit Comm Settings menu
To make changes to the DHCP mode, IP address, gateway address, and subnet mask,
access the editing screens as follows:
1. Press the
2. Press the
screen (approximately 5 seconds).
3. Press
NOTE: The Serial Port and MAC Address settings cannot be edited and remain
view-only in Edit mode.
4. To change the DHCP mode setting:
a. Press
b.
Rotate either
NOTE: DHCP must be set to
5.
To enter or change information on any address screen:
Rotate the horizontal
•
setting.
Rotate the vertical
•
6. When finished editing the settings for the selected item, either press
editing screen for the next item, or press
menu (
menu is an editable version of the
button until the
Menu View Comm Settings
button and hold it until
Next
repeatedly to cycle through the
Next
until is displayed on the LCD screen.
Next DHCP Mode
knob to select
Adjust
or the subnet mask.
Adjust
knob ( { ) to increment or decrement the setting.
Adjust
).
Quick Setup
View Comm Settings
menu is displayed.
Edit Comm Settings
Edit Comm Settings
or .
On Off
to edit the IP address, the gateway address,
Off
knob ( [ ) to move the focus (blinking) to the desired
to exit edit mode and display the next
Menu
MediaPort 200 • Front Panel Operation
menu.
appears on the LCD
menu items.
to display the
Next
78