Adjusting Mix Levels - Extron electronics MediaPort 200 User Manual

Adjusting Mix Levels

To access the PCS software
1. On the PCS main window, click the
2. On the
displayed.
Figure 90.
The following adjustments are available from the
Setting the Room Volume
On the
Mix
1.
Set the
level to start playback.
2. Play the program sources, one at a time.
3. Switch among the inputs and use the faders in the
level of each line input source, so that each program source plays back at about the
same level.
4. Readjust the
room. A final setting of -10 for this fader leaves some room for the volume to be
increased if needed (this depends on the size of the amplifier in the room and its input
sensitivity setting).
5. Adjust the
comfortable and intelligible listening level for speech from the far end.
screen:
Mix
screen, click the
Audio Configuration
Settings on the Mix Screen
screen, set the following master faders as follows:
master fader (see figure 90
Room Volume
master fader (
Room Volume
fader (
USB Communications
MediaPort 200 • with External DSP with AEC Application Setup
button (see figure 90
Audio Config
tab ( ). The
Mix 2
screen:
Mix
above) to -20 dB. This is a safe
5
Program Mix
) to a comfortable listening level for the
5
) during an active conference to set a
4
below).
1
screen is
Mix
panel ( ) to set the
3
110