Output Configuration Menu - Extron electronics DVC 501 SD User Manual

Output Configuration Menu

The output configuration menu allows you to set the output resolution and refresh rate, the
output signal type, and the sync polarity (RGBHV only). The following flow diagram shows
the output configuration submenus and the adjustments that can be made from them.
Use either Adjust knob to
select a submenu option.
Figure 15.
The output format and sync polarity can be configured for both the analog and DVI
outputs. The color space affects both outputs, and the sync polarity is transmitted in the DVI
information frame for the display to interpret if necessary.
Format submenu
Rotate either the horizontal ([) or the vertical ({) Adjust knob to select the output video
format required by the display. Available signal types are RGBHV (default), RGBS, RGsB,
YUV bi-level, and YUV tri-level.
NOTE: Setting the sync format to YUV bi-level and tri-level also affects the colorspace of the
Sync Polarity submenu
The display device may require a particular combination of horizontal (H) and vertical (V) sync
signal polarities. Select the appropriate combination of positive or negative H and V sync by
rotating either the horizontal ([) or vertical ({) Adjust knob. Options are
or H+V+ (default).
Resolutions and refresh rates
The output resolution and refresh rate follow those of the source device. The table below
shows the resolutions and refresh rates on the DVC 501 SD.
Resolution/
Rate
720p
1080i
1080p
NTSC
PAL
Default
Cycle
Menu
OUTPUT
Next
CONFIG
Select the signal format:
RGBHV (default)
•
• RGBS
• RGsB
• YUV Bi-Level
• YUV Trilevel
Output Configuration Menu
DVI output.
23.98 Hz 24 Hz 25 Hz
X X
*This screen appears only if
RGBHV is selected for the format.
FORMAT H
Next
RGBHV
POS
Select the sync polarity
combination (Horizontal
and Vertical):*
• Neg
• Neg
• Pos
• Pos
29.97 Hz 30 Hz 50 Hz 59.94 Hz 60 Hz
X X X
X X X
DVC 501 SD • Operation
SYNC V
POS
Next
Neg
Pos
Neg
Pos (default)
, , ,
H-V- H+V- H-V+
X X X
X X X
X X X
X
X
13