View Comm Settings Menu - Extron electronics MediaPort 200 User Manual

Overscan — Select a default overscan mode to apply to SMPTE input rates (480i,
•
576i, 480p, 576p, 720p, 1080i, and 1080p). Overscan zooms and crops SMPTE
inputs to mask edge effects and ancillary data that may occur in broadcast signals. The
selections are
NOTE: If the overscan mode is not 0%, when Auto-Image is performed on an
SMPTE input rate, it refers to the default input values for sizing and positioning
instead of performing a true Auto-Image.
• Internal Temp. — (Read only) Shows the internal temperature of the unit in Fahrenheit
(left value) and Celsius (right value).
• Part number and firmware version — (Read only) Displays the unit part number
(60-1488-01) and the firmware version and build (for example,
Reset — Reset the unit to its factory-installed values (removing any user-defined
•
values) while retaining the current firmware version. Rotate either
Factory Reset
these menus).
The equivalent SIS command for this reset is <
see Resetting

View Comm Settings Menu

The
View Comm Settings
the IP, subnet mask, and gateway addresses, the MAC (Media Access Code or hardware)
address, the Dynamic Host Configuration Protocol (DHCP) status, and the serial port baud
rate and type.
NOTE: None of the settings can be changed from this menu. To make adjustments, use
the Edit Comm Settings menu (see
Figure 75 below shows the screens and the settings that can be viewed from this menu.
Configuration
Serial Port
9600
View the RS-232 port parameters.
Next
View the subnet mask IP address.
Figure 75.
(the default),
0% 2.5%
Resetting
(see on page 80 for the complete reset procedure using
on page 80.
menu shows the current communication ports settings, including
Advanced
Menu
View Comm
Settings
Next
Next
8 N 1
View the Media Access Code (MAC)
hardware address.
Subnet Mask Gateway Address
Next
255.255.0.0
View the gateway IP address.
View Comm Settings Menu Flow
, and .
5%
> } . For other reset methods,
Esc ZXXX
Edit Comm Settings Menu
MAC Address
Next
0005A60989CD
View Dynamic Host
Configuration Protocol (DHCP)
Next
0.0.0.0 192.168.254.254
View the unit internet address.
MediaPort 200 • Front Panel Operation
).
v1.00.0009-b004
knob to select
Adjust
on the next page).
DHCP Mode
Off
Next
IP Address
77