Extron electronics MediaPort 200 User Manual page 158

HDMI Status — Shows the resolution and refresh rate (
1
DVI) input and loop-out (
compliance of the attached sink (
NOTES:
• The panel (
Input
input signal type.
• The panel (
Loop-Out
output format that has been set.
Figure 95. HDMI Status Panel with HDCP Encrypted
• Input panel:
If the input signal is HDCP encrypted, the Input status field displays a closed
•
lock icon followed by HDCP (see figure 95
If the input signal is NOT HDCP encrypted, the Input status field displays an
•
open lock icon, followed by HDCP.
If no device is connected to the HDMI input, the input status field displays a
•
dash (–).
• Loop-Out panel:
If the attached sink is HDCP compliant, the loop-out status field (
•
lock icon with a check mark.
If the sink is non-HDCP compliant, this field displays an open lock icon with an
•
X on it.
If no device is connected to the Loop Out connector, the Loop-Out status
•
field displays a dash.
USB Status — This read-only panel indicates whether a USB host is present,
2
whether video and audio is being streamed, and if audio is being returned through this
connection input. It also displays the USB output resolution group, resolution rate, and
the USB streaming format.
), the input HDCP encryption status (
4
).
6
) displays either or
2
HDMI
) displays either
5
HDMI
above).
3
MediaPort 200 • Remote Configuration and Control
below) of the HDMI (or
1
) and the HDCP
3
, depending on the detected
DVI
or , depending on the loop
DVI
) displays a
6
151