Extron electronics MediaPort 200 User Manual page 88

Mode Activation
1 Hold in the rear panel
button while applying power to the
MediaPort 200.
4 Hold in the
Reset
Reset LED blinks twice (once after
approximately 3 seconds and
again after 6 seconds). Then, within
1 second, press
Reset
(for less than 1 second).
5 Hold in the
Reset
Reset LED blinks three times (once
after approximately 3 seconds, again
after 6 seconds, and then again after
9 seconds). Then, within 1 second,
press momentarily (for less than
Reset
1 second).
NOTE: Mode 5 reset clears all user settings. To save these settings, use the PCS control program
and select
Backup
MediaPort 200 Help file for more information).
Reset Modes Summary
Result
• Loads the factory firmware version for
Reset
a single power cycle.
• Retains all user files and settings,
including drivers, audio adjustments,
and IP settings.
button until the • Sets the IP address, subnet mask,
and gateway address to the factory
defaults.
Sets port mapping to the factory
•
momentarily
default.
• Sets DHCP to Off.
The Reset LED blinks four times in quick
succession during the reset.
button until the Performs a complete reset to factory
defaults except the firmware.
• Does everything that mode 4 does.
• Resets all user-modifiable
configuration to default values,
including IP settings and real-time
adjustments.
• Deletes all user-loaded files, including
images.
The Reset LED blinks four times in quick
succession during the reset.
from the
MediaPort 200
tab menu before this reset is performed (see the
MediaPort 200 • Front Panel Operation
Purpose
Use mode 1 to
temporarily load
factory firmware
if incompatibility
issues arise.
Mode 4 sets all
IP information to
factory defaults.
It does not replace
any user-installed
firmware.
This is the
equivalent of
the SIS
1ZQQQ
command.
Mode 5 is useful
to start over
with the default
configuration.
This is equivalent to
the SIS command
.
ZQQQ
81